Raising Compression?
Just wondering if anyone has tried milling the cylinder head or use a thinner gasket to raise the compression at all? The thought is that if this engine is only 9:1, it should see some decent gains is the compression was raised to like 10:1.
Any thoughts??? |
Quote:
If you are sitting there contemplating a thinner head gasket to make your 249cc cruiser go .0007 mph faster then I guarantee you don't have the skill to properly assemble an engine. So just forget it. |
All times are GMT -4. The time now is 12:31 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.