Go Back   GZ 250 Forums > Search Forums

Showing results 1 to 25 of 103
Search took 0.01 seconds.
Search: Posts Made By: derbydave
Forum: Troubleshooting 03-26-2019, 06:16 PM
Replies: 10
Views: 2,082
Posted By derbydave
The two bolts on the back arms of the swing arm...

The two bolts on the back arms of the swing arm are used to adjust wheel alignment in the swing arm. The chain should run true between the two sprockets when it is adjusted correctly. Also have the...
Forum: General GZ250 Talk 03-18-2019, 05:55 PM
Replies: 16
Views: 6,051
Posted By derbydave
While it would be relatively inexpensive to fix...

While it would be relatively inexpensive to fix with used parts from ebay. I would be very suspicious of the geometry of rest of the frame. If it is tweaked, which is very possible given the front...
Forum: Performance 10-13-2018, 08:34 AM
Replies: 12
Views: 15,467
Posted By derbydave
87 Octane Ethanol free. I don't ride my GZ as...

87 Octane Ethanol free. I don't ride my GZ as much, Ethanol starts to go bad in a few weeks so I don't want it sitting in the tank. I also add a little Marvel Mystery Oil to the gas at each fill...
Forum: General Maintenance 09-04-2018, 12:25 PM
Replies: 8
Views: 3,466
Posted By derbydave
You guys do realize this guys channel is parody...

You guys do realize this guys channel is parody right
Forum: General Maintenance 08-20-2018, 05:17 PM
Replies: 1
Views: 1,711
Posted By derbydave
https://www.youtube.com/watch?v=3FmfO-mWv3Q&t=0s&l...

https://www.youtube.com/watch?v=3FmfO-mWv3Q&t=0s&list=LLiE4jAylZbhrHn5eNh0CE2g&index=94
Forum: General GZ250 Talk 08-01-2018, 02:31 PM
Replies: 8
Views: 2,739
Posted By derbydave
What did you pay for your GZ

How much did you pay for your GZ? I paid $500 but my bike needed work and wasn't in rideable condition.
Forum: General Maintenance 07-26-2018, 02:58 PM
Replies: 8
Views: 1,777
Posted By derbydave
Most of the electrical connections terminate in...

Most of the electrical connections terminate in the headlight bucket. Take the light out and look in there for anything obvious, loose connections, burnt wires ect. If that fails you really need a...
Forum: General GZ250 Talk 07-20-2018, 10:32 AM
Replies: 7
Views: 3,955
Posted By derbydave
Go for it! This is my GZ before and after I...

Go for it! This is my GZ before and after I restored it.
Forum: Troubleshooting 05-25-2018, 11:29 PM
Replies: 8
Views: 4,338
Posted By derbydave
It sounds like to me you found your culprit. I...

It sounds like to me you found your culprit. I would remove the starter and bench test it. You should be able to tell if it shorts or draws excessive current.
Forum: Troubleshooting 05-17-2018, 11:01 PM
Replies: 8
Views: 4,338
Posted By derbydave
Short to ground somewhere. Check all the wires...

Short to ground somewhere. Check all the wires for melted or chaffed insulation. including inside the headlight bucket. Disconnect the starter and test to see if the problem still exists.
Forum: Troubleshooting 05-17-2018, 10:59 PM
Replies: 11
Views: 5,809
Posted By derbydave
Take the battery to an auto store and see if they...

Take the battery to an auto store and see if they can load test it for you
Forum: Troubleshooting 05-17-2018, 06:09 PM
Replies: 11
Views: 5,809
Posted By derbydave
Did you check all 3 phases of the stator while...

Did you check all 3 phases of the stator while running. Check 1 and 2, 2 and 3, and 3 and 1. All phases should be producing AC current while running.
Forum: Troubleshooting 05-15-2018, 06:14 PM
Replies: 6
Views: 1,648
Posted By derbydave
There is a rod (rear torque link) that connects...

There is a rod (rear torque link) that connects between the drum housing and the frame that prevents the shoe assembly from rotating with the braking forces. Check the fasteners and make sure they...
Forum: Troubleshooting 05-09-2018, 05:38 PM
Replies: 2
Views: 1,027
Posted By derbydave
did you clean and service the idle circuit and...

did you clean and service the idle circuit and o-ring under the brass plug on the bottom? Even if it seems to idle ok that circuit can cause problems when the throttle plate is opened.

You might...
Forum: Parts & Accessories 05-02-2018, 03:38 PM
Replies: 20
Views: 4,255
Posted By derbydave
If It was me I would completely tear down and...

If It was me I would completely tear down and clean the carb and install a complete carb rebuild kit like this one.

https://www.allballsracing.com/26-1659.html
Forum: Parts & Accessories 04-30-2018, 04:22 PM
Replies: 20
Views: 4,255
Posted By derbydave
It sure sounds like it is starving for fuel. The...

It sure sounds like it is starving for fuel. The blued exhaust pipes even indicate running lean. How is the petcock? have you tried running it in the prime position?
Forum: Parts & Accessories 04-30-2018, 09:50 AM
Replies: 20
Views: 4,255
Posted By derbydave
The carb will come off without pulling the air...

The carb will come off without pulling the air box or engine. Did you replace any of the seals and o-rings? It sounds like an air leak, or blocked passage in the carb body.
Forum: Troubleshooting 04-23-2018, 11:36 PM
Replies: 1
Views: 941
Posted By derbydave
Probably the side stand/Turn Signal Relay located...

Probably the side stand/Turn Signal Relay located under the seat next to the fuse box. Check it with a meter. I have attached the manual pages showing how to test it although it looks like it is...
Forum: Parts & Accessories 04-18-2018, 12:55 PM
Replies: 20
Views: 4,255
Posted By derbydave
When you had it apart did you replace the seals...

When you had it apart did you replace the seals and O-rings? How is the diaphragm for the slide? If it has any holes or is torn it won't run right.
Forum: Parts & Accessories 04-18-2018, 11:00 AM
Replies: 20
Views: 4,255
Posted By derbydave
Have you tried rebuilding the current carb? They...

Have you tried rebuilding the current carb? They are really easy and cheap to rebuild
Forum: Member Introductions 04-11-2018, 05:21 PM
Replies: 7
Views: 1,627
Posted By derbydave
https://www.ebay.com/itm/1-NEW-Genuine-SUZUKI-GZ25...

https://www.ebay.com/itm/1-NEW-Genuine-SUZUKI-GZ250-GZ-250-EMBLEM-DECAL-STICKER-68131-12F40-LK6-NOS-Part/323193959787?epid=12016195458&hash=item4b3fdc756b:g:gL8AAOSw-WFaoFyg&vxp=mtr

I left mine...
Forum: Troubleshooting 03-28-2018, 06:17 PM
Replies: 13
Views: 2,239
Posted By derbydave
You might also use a meter on the disconnected...

You might also use a meter on the disconnected ground wire and test for voltage being shorted to ground. One probe on the ground wire and the other on the battery negative terminal. There should be...
Forum: Troubleshooting 03-28-2018, 04:57 PM
Replies: 13
Views: 2,239
Posted By derbydave
Check the side stand switch and the side stand...

Check the side stand switch and the side stand relay. I was looking over the wiring diagram and those two look like they could be suspect. I would pull the side stand relay and disconnect the side...
Forum: Troubleshooting 03-28-2018, 04:34 PM
Replies: 13
Views: 2,239
Posted By derbydave
Here is an English one. It's hard to read though

Here is an English one. It's hard to read though
Forum: Troubleshooting 03-28-2018, 10:11 AM
Replies: 13
Views: 2,239
Posted By derbydave
I tried replacing my stock ignition switch with...

I tried replacing my stock ignition switch with an aftermarket when I first got my bike due to not having the key. The aftermarket switch would blow the 20 amp main fuse every time I went to turn it...
Showing results 1 to 25 of 103

 
Forum Jump

All times are GMT -4. The time now is 07:10 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.