View Single Post
Old 11-16-2017, 05:36 PM   #15
lowbeam
Junior Member
 
Join Date: Oct 2017
Posts: 10
If anyone was following this I finally figured out the issue. The choke plunger and its seat were dirty and sticking half open or not sealing properly. It seemed like it was slowly leaking and then letting a drop of fuel leak into the engine and causing a small vacuum leak at the same time. I polished up the plunger and cleaned where it sits with a carb cleaner and a q tip and cleaned and lubed up the spring and holder and the bike is idling consistently and running good now. I still have to dial in the idle mixture when its hot as it bogs slightly when I give it some throttle.



Login or Register to Remove Ads
lowbeam is offline  
Reply With Quote