GZ 250 Forums - View Single Post

Razorburns · 02-24-2018, 06:18 PM

Ok. What should have been a fast 15 minute job turned out to be an extended exercise in minor frustrations.

First the bolts that came with the risers that go through into the top of the tree were just a fraction of a hair too thick to go through the hole. Then once I got new bolts from the store that DO fit through, I found that the threads weren't the same and the old lock luts wouldn't thread on the the new bolts. Then when I had everything correct sized and thread............. it started to rain while I was putting it together again.

So, hours later it's all together but I was frustrated and didn't even bother taking photos.

They look awesome. You'll just have to trust me on this.

02-24-2018, 06:18 PM	#2
Razorburns Member Join Date: May 2017 Location: Portland Oregon Posts: 66	Ok. What should have been a fast 15 minute job turned out to be an extended exercise in minor frustrations. First the bolts that came with the risers that go through into the top of the tree were just a fraction of a hair too thick to go through the hole. Then once I got new bolts from the store that DO fit through, I found that the threads weren't the same and the old lock luts wouldn't thread on the the new bolts. Then when I had everything correct sized and thread............. it started to rain while I was putting it together again. So, hours later it's all together but I was frustrated and didn't even bother taking photos. They look awesome. You'll just have to trust me on this. Last edited by Razorburns; 02-25-2018 at 07:32 AM.
	0