|
When i installed mine, I didnt drill any holes. I found a two inch bracket in my garage (two inch piece of metal with proper holes on each end). I removed the stock horn. Attached one end of the bracket in place of the stock horn, then mounted my steubel to the other end.
I attached my relay behind the right side reflector (I removed the nut holding the reflector, the bolt was long enough to add the relay and reattach the nut).
I used the existing horn wires to connect to the relay switch, connected the other wires to the horn, connected the ground wire (used existing bolt on top of forks), ran a hot wire to the battery and bingo.
Basically same as Quimrider but I didnt run existing horn harness/wires to the back of the back (airbox area).
If I can get the camera from the wife, and I dont forget, i will take pictures of my setup and add them this weekend.
|