View Single Post
Old 07-25-2017, 11:50 PM   #35
kilo0195
Member
 
Join Date: Jul 2017
Location: Illinois
Posts: 52
This is what I made. Used 3/8 steel rod, steel sheet (Don't remember gauge), and 3/8 square tube. Cut a design out of the sheet to look well with or without saddle bags. I also wanted a sissy bar that was easy to remove which is where the square tube comes in. I closed of the bottom and welded it to the plate. The sissy bar then just slides down into the tube and bracket for about a 5 second install or removal. At the top of the bar I welded in a "t" bracket from the hardware store so that I had something to bolt the pad to. Cost me about $24 and 3 hours.



Login or Register to Remove Ads

Last edited by kilo0195; 07-25-2017 at 11:53 PM.
kilo0195 is offline  
Reply With Quote