GZ 250 Forums - View Single Post - Just got to pick a good time to install this

spldart · 06-03-2016, 09:20 PM

Couldn't resist. Opened the rings packet and slid a compression ring into the cylinder, squared it up with the piston and checked ring gap. Service limit is .5 mm. I got .22. Looks like this will just throw together with no ring gap filing.
Edit
Just checked wiseco charts and found the rings are very close to perfect gap.
So out of the box looks good.

Again. Still. Installation will tell.

06-03-2016, 09:20 PM	#5
spldart Senior Member Join Date: May 2015 Location: Stafford, Texas Posts: 604	Couldn't resist. Opened the rings packet and slid a compression ring into the cylinder, squared it up with the piston and checked ring gap. Service limit is .5 mm. I got .22. Looks like this will just throw together with no ring gap filing. Edit Just checked wiseco charts and found the rings are very close to perfect gap. So out of the box looks good. Again. Still. Installation will tell. Login or Register to Remove Ads Last edited by spldart; 06-03-2016 at 09:25 PM.
	0