GZ 250 Forums - View Single Post

lowbeam · 11-04-2017, 07:26 PM

Update on the bike, I am installing a pod filter to get rid of the air box and eliminate some variables. I have a couple questions.

The mixture screw is the tall post that sticks out of the bottom of the carb on the engine side correct? It seems someone else already drilled out the plug but I see another center punched brass plug tucked down between that post and the float bowl. I am assuming there is another adjustment screw there (could be wrong), should I drill that plug out as well or just leave it?

Another thing I noticed on the top of the carb on the air and throttle side there is a hole that goes down to the float bowl (I noticed when fuel was leaking out of it after I turned the carb sideways) Is this supposed to be plugged or open?

11-04-2017, 07:26 PM	#10
lowbeam Junior Member Join Date: Oct 2017 Posts: 10	Update on the bike, I am installing a pod filter to get rid of the air box and eliminate some variables. I have a couple questions. The mixture screw is the tall post that sticks out of the bottom of the carb on the engine side correct? It seems someone else already drilled out the plug but I see another center punched brass plug tucked down between that post and the float bowl. I am assuming there is another adjustment screw there (could be wrong), should I drill that plug out as well or just leave it? Another thing I noticed on the top of the carb on the air and throttle side there is a hole that goes down to the float bowl (I noticed when fuel was leaking out of it after I turned the carb sideways) Is this supposed to be plugged or open? Last edited by lowbeam; 11-04-2017 at 07:59 PM.
	0