GZ 250 Forums - View Single Post

bschift · 08-21-2014, 08:03 PM

Well, I made these stands but I must be missing something. When I try to slide it under the swing arm on the right side the bottom of the stand hits the tire before it gets under the swing arm. I checked all my measurements and they seem to be right. I can straighten the bike up then push the stand under the swing arm from the right, but this is a little dicey for a one-man operation. Does my stand just lean to much? Has anyone else seem this?

Thanks.

08-21-2014, 08:03 PM	#42
bschift Junior Member Join Date: Aug 2013 Location: Whitney, TX Posts: 13	Why am I the only stupid one. Well, I made these stands but I must be missing something. When I try to slide it under the swing arm on the right side the bottom of the stand hits the tire before it gets under the swing arm. I checked all my measurements and they seem to be right. I can straighten the bike up then push the stand under the swing arm from the right, but this is a little dicey for a one-man operation. Does my stand just lean to much? Has anyone else seem this? Thanks.
	0