Yesterday I did a few small things the main one it needed was the needle shim. It seems a bit happier now.
Found a hole in the header which I'll fix with some exhaust cement.
White heatwrap on the headers which looks better than rust.
Flaming chopper mirriors which are not mounted properly because factory mounts are rusted solid.
Purple Dupli-Color metalcast paint (looks anodized) On the upper engine shrouds. Looks funny because I need sandpaper to fix the corrosion on the lower cases but once done it should be better.
Couldn't find a GZ250 front fender but I have a VL250 front one coming. It will be a cut and plastic weld job and it will be going on the back.
I have a slash cut 16" rear muffler coming too. I want to get it welded if I can but depends on how much as this is a diy fun low budget build.
Waiting on the HFA 3503 Air filter. And then it will be time to get some jets. And some steel bracing so I can make my own saddlebag mounts.