GZ 250 Forums - View Single Post - Generator / Rotor Bolts

clofan · 03-27-2014, 01:35 PM

Oh yeah, definitely waited until it cured this time. Quiksteel worked great for this.. its malleable nature allowed me to form the shape I wanted before pressing it into place. I let it harden for a few hours, checked it, and buttoned her back up. Put fresh oil in, and it started perfectly and is running strong! Actually only ran it for a few seconds last night, no leaks as of this morning. I plan to ride it for 50-100 miles then change the oil again. I'll check my weld at that time, and if we're all good then it will be ready for riding!

03-27-2014, 01:35 PM	#17
clofan Junior Member Join Date: Mar 2014 Posts: 29	Oh yeah, definitely waited until it cured this time. Quiksteel worked great for this.. its malleable nature allowed me to form the shape I wanted before pressing it into place. I let it harden for a few hours, checked it, and buttoned her back up. Put fresh oil in, and it started perfectly and is running strong! Actually only ran it for a few seconds last night, no leaks as of this morning. I plan to ride it for 50-100 miles then change the oil again. I'll check my weld at that time, and if we're all good then it will be ready for riding! Last edited by clofan; 03-27-2014 at 01:43 PM.
	0