Quote:
Originally Posted by Water Warrior 2
Is the float a hollow metal float? If it is, it may have developed a pin hole and is filling up so it won't really float as it should. If that is the problem then just let the float dry out and solder over the pin hole if you can find it. Re-assemble and set the float to the proper specs.
This is just a wild a$$ guess because I know nothing about the innards of a carb.
|
I have seen those hollow metal bronze-ish floats too....
One can solder a pinhole yes but be EXTREMELY careful to totally dry it out as
WatWar2 says.
An optimal air fuel ratio packs quite the 'bang' if it ignites.. heat or otherwise.