GZ 250 Forums - View Single Post

kirk · 12-13-2010, 10:04 AM

Just got the Baron's Engine Guard out of the shipping box. Will install it later and update with more information about clearance, etc.
For now - the measurements are 25 inches center-to-center from side to side.
From top to bottom, it is slightly trapezoidal. At its widest point (which is the centerline where it hooks up to the frame), it's about 12.5 inches center-to-center from top to bottom
At its narrowest out at the edge, its about 11 inches center-to-center from top to bottom.
Top bar across is straight, at the bottom is where the supports angle downward.
Its hefty - weighs in at 9lbs. Since its at the front of the bike though maybe this will add to stability?

12-13-2010, 10:04 AM	#7
kirk Junior Member Join Date: Dec 2010 Location: South Philly Posts: 8	Re: Baron Engine Guard????? Just got the Baron's Engine Guard out of the shipping box. Will install it later and update with more information about clearance, etc. For now - the measurements are 25 inches center-to-center from side to side. From top to bottom, it is slightly trapezoidal. At its widest point (which is the centerline where it hooks up to the frame), it's about 12.5 inches center-to-center from top to bottom At its narrowest out at the edge, its about 11 inches center-to-center from top to bottom. Top bar across is straight, at the bottom is where the supports angle downward. Its hefty - weighs in at 9lbs. Since its at the front of the bike though maybe this will add to stability?
	0