New gz250, need help!

lowbeam · 11-06-2017, 09:59 PM

To anyone interested: pod filter is on(52mm, a 50mm would probably fit as well), open exhaust, 140 main jet and the washer from the needle switched to the other side of the clip. Pilot screw is turned all the way out and it pulls good at higher rpm now. Idle is still just okay. I might put in a bigger pilot jet but I am not sure how restrictive the screw needle is. I am thinking of sizing up the pilot jet and shimming the needle with another washer to smooth everything out but it is running pretty well as is. Need to check for any leaks in case that is my problem and figure out a mount for the battery other than the zipties I have around it as the battery rests against the air box which I don't have on my bike anymore.

11-06-2017, 09:59 PM	#11
lowbeam Junior Member Join Date: Oct 2017 Posts: 10	To anyone interested: pod filter is on(52mm, a 50mm would probably fit as well), open exhaust, 140 main jet and the washer from the needle switched to the other side of the clip. Pilot screw is turned all the way out and it pulls good at higher rpm now. Idle is still just okay. I might put in a bigger pilot jet but I am not sure how restrictive the screw needle is. I am thinking of sizing up the pilot jet and shimming the needle with another washer to smooth everything out but it is running pretty well as is. Need to check for any leaks in case that is my problem and figure out a mount for the battery other than the zipties I have around it as the battery rests against the air box which I don't have on my bike anymore. Login or Register to Remove Ads
	0