Oil Quantity

2003gzsc · 06-30-2012, 09:28 PM

After searching the manual and this forum, the consensus is that my 2003 gz250 should take no more than 2 quarts of oil. HOWEVER, I just changed the oil on it. There was less than 1 quart of oil in the engine when I drained it. I replaced the oil in the engine with 2 quarts. I ran the bike for several minutes and waited a few minutes and checked the inspection window. It was dry. Barely a spray of oil was noticeable and certainly nowhere near the "L" line. :shocked:

Should I add more oil? If so, how much is safe to add? Has anyone ever had a similar problem like this?

Thanks for the help!

JWR · 06-30-2012, 09:53 PM

The GZ takes less than 1 and 1/2 quarts.

The sight glass would be over the full mark with 2 quarts.

The side of the engine is stamped with the correct amount in mls.
1400 if I remember right.

You are checking the oil with the bike upright, not on the sidestand,???

**jonathan180iq** · 06-30-2012, 11:00 PM

http://www.gz250bike.com/forum/viewtopic.php?f=8&t=566

"Once the new filter is installed, bolt the cover back on and re-install the oil drain bolt. You then need to fill the bike with 1.5 quarts of your favorite oil. If you are not changing the filter, I believe you only need to use 1.4 quarts."

OldNTired · 06-30-2012, 11:14 PM

Quote:

Originally Posted by 2003gzsc

After searching the manual and this forum, the consensus is that my 2003 gz250 should take no more than 2 quarts of oil. HOWEVER, I just changed the oil on it. There was less than 1 quart of oil in the engine when I drained it. I replaced the oil in the engine with 2 quarts. I ran the bike for several minutes and waited a few minutes and checked the inspection window. It was dry. Barely a spray of oil was noticeable and certainly nowhere near the "L" line. :shocked:

Should I add more oil? If so, how much is safe to add? Has anyone ever had a similar problem like this?

Thanks for the help!

I think what you did was overfill it to the point where
the sight glass is below the level of the oil!
Try draining a half quart or so, then see what happens.
Remember to check the level with the bike straight
up and down, NOT resting on the kickstand. What I do is
to rst the kickstand on a short piece of 2x4.

2003gzsc · 06-30-2012, 11:34 PM

Could it do any damage to the engine if it is overfilled?

blaine · 07-01-2012, 12:08 AM

Quote:

Originally Posted by 2003gzsc

Could it do any damage to the engine if it is overfilled?

Not for a short time.If left over filled it can cause seals & gaskets to blow & leak.

:cool:

Water Warrior 2 · 07-01-2012, 01:09 AM

Think Metric. 1300 ml of oil without a filter change. 1400 ml with a filter change.

Just made a correction, now I feel better.

2003gzsc · 07-01-2012, 09:01 AM

Thank guys. I put in 1900ml. So I only need to drain 500ml.

OldNTired · 07-01-2012, 11:56 PM

Quote:

Originally Posted by 2003gzsc

Thank guys. I put in 1900ml. So I only need to drain 500ml.

Have fun draining it out!

Remember, it comes out a lot faster than when
filling it.
First time I did that, I drained over half of the oi out before I
realized how fast it was draining.

Water Warrior 2 · 07-02-2012, 02:45 AM

Probably easiest to drain it all out and refill as needed.

06-30-2012, 09:28 PM	#1
2003gzsc Junior Member Join Date: Jun 2012 Location: South Carolina Posts: 11	Oil Quantity After searching the manual and this forum, the consensus is that my 2003 gz250 should take no more than 2 quarts of oil. HOWEVER, I just changed the oil on it. There was less than 1 quart of oil in the engine when I drained it. I replaced the oil in the engine with 2 quarts. I ran the bike for several minutes and waited a few minutes and checked the inspection window. It was dry. Barely a spray of oil was noticeable and certainly nowhere near the "L" line. :shocked: Should I add more oil? If so, how much is safe to add? Has anyone ever had a similar problem like this? Thanks for the help! Login or Register to Remove Ads
	0

06-30-2012, 09:53 PM	#2
JWR Senior Member Join Date: Jan 2009 Location: Louisville, TN Posts: 1,413	Re: Oil Quantity The GZ takes less than 1 and 1/2 quarts. The sight glass would be over the full mark with 2 quarts. The side of the engine is stamped with the correct amount in mls. 1400 if I remember right. You are checking the oil with the bike upright, not on the sidestand,??? __________________ Jerry Truth is there are lots of great bikes available and not nearly as many good riders out there riding them... "A man's got to know his limitations..."
	0

06-30-2012, 11:00 PM	#3
jonathan180iq Super Moderator Join Date: Jan 2007 Location: Dalton, GA Posts: 3,996	Re: Oil Quantity http://www.gz250bike.com/forum/viewtopic.php?f=8&t=566 "Once the new filter is installed, bolt the cover back on and re-install the oil drain bolt. You then need to fill the bike with 1.5 quarts of your favorite oil. If you are not changing the filter, I believe you only need to use 1.4 quarts." Login or Register to Remove Ads
	0

06-30-2012, 11:34 PM	#5
2003gzsc Junior Member Join Date: Jun 2012 Location: South Carolina Posts: 11	Re: Oil Quantity Could it do any damage to the engine if it is overfilled? Login or Register to Remove Ads
	0

07-01-2012, 01:09 AM	#7
Water Warrior 2 Senior Member Join Date: Dec 2006 Location: Squamish B.C Canada Posts: 11,409	Re: Oil Quantity Think Metric. 1300 ml of oil without a filter change. 1400 ml with a filter change. Just made a correction, now I feel better.
	0

07-01-2012, 09:01 AM	#8
2003gzsc Junior Member Join Date: Jun 2012 Location: South Carolina Posts: 11	Re: Oil Quantity Thank guys. I put in 1900ml. So I only need to drain 500ml.
	0

07-02-2012, 02:45 AM	#10
Water Warrior 2 Senior Member Join Date: Dec 2006 Location: Squamish B.C Canada Posts: 11,409	Re: Oil Quantity Probably easiest to drain it all out and refill as needed.
	0