Register Community Calendar Today's Posts Search

Go Back   GZ 250 Forums > GZ250-Specific > Troubleshooting

Reply
 
Thread Tools Display Modes
Old 01-07-2008, 04:37 PM   #21
jonathan180iq
Super Moderator
 
jonathan180iq's Avatar
 
Join Date: Jan 2007
Location: Dalton, GA
Posts: 3,996
Well, exhaust systems aren't closed systems. There is always ambient flowing around air inside the muffler. For example, if you look at the bottom of the muffler, you can see little holes which allow trapped moisture to escape and which also let outside air in.

As far as what you were describing, slight popping and gurgling sounds aren't considered afterfire. And I have experienced then also when in a lean mixture.
Afterfire is the serious bang that everyone has heard at some point in their lives, but it comes out of the exhaust.

Like I said, it is mistakenly referred to as backfire.

I'm not a chemist or physics expert, so it's possible that afterfiring can occur in a lean mixture, I just don't see how it could happen. When there is too much air in cylinder, an engine doesn't experience a proper explosion. It would make sense to me that a lean mixture which carries over into a muffler would then encounter even more air, which would essentially kill the flame.

I may be wrong, but I'm pretty sure that's how it works.



Login or Register to Remove Ads
jonathan180iq is offline  
Reply With Quote
Old 01-14-2008, 06:13 PM   #22
trykemike
Senior Member
 
Join Date: May 2007
Location: toronto ont canada
Posts: 177
choke

Hey Easy thanks for the correction I went on-line and read about cv carbs . The word " choke " is a legacy term as you pointed out the " enricher " circuit provides a richer mixture. I did some testing in late Oct and early Nov . In cold weather ( 40 F ) I applied a little " choke " when the top speed maxed @ 65 approx 6500 rpm and top went to 70 and 7000 rpm. It dropped back to 6500 rpm after opening " choke " again.

This is just an observation .

I have a tach .
__________________
sds4
trykemike is offline  
Reply With Quote
Old 01-14-2008, 07:08 PM   #23
Easy Rider
Senior Member
 
Join Date: May 2007
Location: Champaign, Illinois
Posts: 4,561
Re: choke

Quote:
Originally Posted by trykemike
I applied a little " choke " when the top speed maxed @ 65 approx 6500 rpm and top went to 70 and 7000 rpm. It dropped back to 6500 rpm after opening " choke " again.

This is just an observation .
Gotta give that a try.
I've always heard that the "enricher" was out of the picture at high load/rpm.
Since it doesn't restrict the input air flow like a real choke, I can imagine that it might still make the mixture a tiny bit richer without "choking" it.
__________________
Loud pipes risk rights!



Login or Register to Remove Ads
Easy Rider is offline  
Reply With Quote
Reply




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:28 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.