03-19-2011, 04:43 PM
|
#1 |
|
Junior Member
Join Date: Apr 2007
Location: Fort Lauderdale
Posts: 25
|
internal carburator part question
Inside the GZ mikuni carb lower body, I am following the disasembly instructions in the manual getting it stripped for a chemical bath. Under the starter jet marked #16 in the manual, there is a brass insert like a jet or a tube, very tiny hole, that has no removal insruction. This insert also has a air hole (in the aluminium body) at the base near the roof of the inside of the lower carb main body (upper opposit end than the lower end the starter jet screws into. Question; does this brass piece come out of the body, is it permanently pressed in or does it have orings that might be damaged by a chemical bath?? --Dan--
__________________
1999 GZ250 - teal green past bikes 100cc twin yamaha-1960's era - first bike 100cc and 125cc honda CB 350cc yamaha twin - 1970 160cc honda -1966 model 350cc honda CB 1970 350cc honda SL 650 Yamaha 1972 F650gs BMW 2007 Virago 750 Yamaha 1996 Login or Register to Remove Ads |
|
|
|
03-19-2011, 05:21 PM
|
#2 |
|
Senior Member
Join Date: Feb 2010
Location: P.E.I. Canada
Posts: 3,784
|
Re: internal carburator part question
It is pressed into the carb and does not come out.The only rubber parts are on the starter plunger (choke) cable.You are good to go.
:cool: 
__________________
If at first you do succeed, try not to look surprised. 
|
|
|
|
 |
|
|
Linear Mode
