Quote:
|
Originally Posted by Vinci
Easy Rider I'm fairly sure I road the bike pretty hard though its been a couple weeks so I can remember if I accelerated hard or not..I will try it in the next few days
Bonehead and Blackbird I will rotate the carb later this week and have a look at it if its only 4 screws needed to have a look at it
Thanks for the responses, I'll reply when I find out whats going down
|
Just don't forget to empty the float bowl before you remove the screws. It's not tragic if you forget, but it is messy.
Just back out this screw (upper arrow) a little and the fuel will drain out of the hole below it (lower arrow.) (Picture taken from Jaime's "GZ250 power increase" thread)
