[JsRedLineRacer]

Ok so i made sure it was plugged in this time and took off. open pipe and a 137.5 main jet (they charged me $15 dollars for it) and 2and3/4 turns on the pilot jet the leaking from the top seemed to stop after i put some gasket stuff on it however it also apprears to be leaking from some lower parts.

Here is a video of how it sounds right now. should i go to a bigger jet since i still get some backfire. Nowhere near how it was at first but its still there.


How can i know which jet i need to buy from ebay so i dont spend so much on the next few jets?

it cut off on me while stopped at a light with the vacum hose connected had to change the petcock to prime to get it to cut on then at home i put it back to on and it seemed to run fine so not sure what happened.

Still getting some white smoke. What could this be? will it stop? it has been used less than 5 miles since i got it to run want to be sure im not going to brake anything before i use it to go to work.

anyways would like some feedback on what you guys think as far as what you can see from the video what do i need to do?

I got it for 500 and so far i have spent about a little less than 100 to get it to where it is.still missing a few hundred more to get it to where i want it. Good deal?

Again thanks for all your help.