Starter Plunger Cable Problems

Canuck · 09-27-2008, 04:22 PM

Easy Rider, I took your advice, put carb cleaner in the tank, checked the starter plunger it is working as far as i can see.
However I am still getting this weird problem when i pull the clutch in past the point of where you would up/downshift, it gets up high in RPM's until i turn the idle screw Super low and back up again to the original and even then it isnt what it should be.
Though i put the carburator back on I'm reluctant to waste more time opening up the float chamber when I take it off again.

:skeptical:

09-27-2008, 04:22 PM	#1
Canuck Senior Member Join Date: Aug 2008 Location: Vancouver Island Posts: 159	Re: Starter Plunger Cable Problems Easy Rider, I took your advice, put carb cleaner in the tank, checked the starter plunger it is working as far as i can see. However I am still getting this weird problem when i pull the clutch in past the point of where you would up/downshift, it gets up high in RPM's until i turn the idle screw Super low and back up again to the original and even then it isnt what it should be. Though i put the carburator back on I'm reluctant to waste more time opening up the float chamber when I take it off again. :skeptical: Login or Register to Remove Ads
	0

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode